completeness button and validations

The following scenario would need some better pop-up messages:

Clicking the Complete button at the end of the data entry screen will
prompt the validation checks to be run. However, if there is a violation,
only the violation will appear as a pop-up, but there should also be some
text explaining that they would have to check up and change the values
that cause the violation before the completeness button will work. As it
is now, you can ignore the validation result, but the complete button will
not work. This caused some confusion here in Sierra Leone, especially as
they are now evaluated according to data completeness (and they got very
frustrated when the button does not react)

OK thats fine, we can put some text there. Could you please add it to Launchpad? Tell me if you need login.

Lars

···

On Fri, May 22, 2009 at 1:32 PM, johansa@ifi.uio.no wrote:

The following scenario would need some better pop-up messages:

Clicking the Complete button at the end of the data entry screen will

prompt the validation checks to be run. However, if there is a violation,

only the violation will appear as a pop-up, but there should also be some

text explaining that they would have to check up and change the values

that cause the violation before the completeness button will work. As it

is now, you can ignore the validation result, but the complete button will

not work. This caused some confusion here in Sierra Leone, especially as

they are now evaluated according to data completeness (and they got very

frustrated when the button does not react)